Here, enter the IP address, subnet mask and default gateway for your network.In the General tab, select the Use the following IP address option.Click on the Internet Protocol Version 4 (TCP/IPv4) option and select Properties. Find the network adapter that you want to set a static IP address and right-click on it and select Properties.This will be either a wired connection (Ethernet cable) or a wireless connection (Wi-Fi). Under the View Your Active Networks section, select the network connection you want to modify. Now, select Network and Sharing Center from the list. To do this, click the Start button and search for the Control Panel and open it. It requires access to the Windows Control Panel, which can be accessed through the Start menu. Setting up a static IP address on Windows is a straightforward process. How To Set Up Static IP Address on Windows Once you have entered the commands, you should be able to access the internet using the static IP address. Open Terminal and enter the following command: networksetup -listallnetworkservices.If you are using a Mac with macOS Sierra or later, you can also use the ‘networksetup’ command in Terminal to set a static IP address: Once you have applied the settings, you should be able to access the internet using the static IP address. Click on DNS from the left sidebar, then click on the + icon and enter the DNS number.Enter the static IP address provided by your ISP/network administrator.Set the Configure IPv4 option to Manually.After selecting the network, click on the Details button.Select the network connection you want to configure from the list on the right side of the window, such as Wi-Fi or Thunderbolt Bridge.The aim of this document is to provide a guide that thoroughly explains the steps of creating and configuring a Loopback Adapter.Follow these steps below to set a static IP address on your Mac: Having the loopback adapter set up is required before installing OBIEE 11g. In fact, Business Intelligence installation will fail for the mentioned environments if the loopback adapter is not properly configured. In order to install the loopback adapter in the Windows 2003 Virtual Machine, you need to:ġ. Go through the ‘ Add Hardware’ wizard (from the control panel).Ģ. Select Next to skip over the first two screens, then select ‘ Yes, I have already added hardware’ and select next again.ģ. Scroll to the bottom of the list on the following screen, and select the ‘ Add a new hardware device’ option, click next again.Ĥ. Select ‘ Install the hardware that I manually select from a list’, and click next.ĥ. Select ‘ Network Adapters’ from device types.Ħ. Select ‘ Microsoft’ as the manufacturer, and ‘ Microsoft Loopback Adapter’ as the Network Adapter.ħ. You’ll need to click next a few more times, then finish. This will add the Microsoft Loopback Adapter as a new Local Area Connection in your Network Connections list. To properly configure the loopback adapter you need to go through the following steps:ġ. Open the Network Connections list, right click on the new network connection (it’s suggested to rename it to Loopback Adapter Connection before) and select properties. Here, you select Internet Protocol (TCP/IP) and click on the Properties button. Image 7: Network connections List / Loopback adapter Connection TCP / IP settingsĢ. From the properties screen for TCP/IP, select ‘ Use the following IP address’ and fill in a loopback IP address (make sure to pick something not within your current subnet!).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |